Send the log data to an external command.
As a development feature, NSO supports sending log data as-is to an external command for reading on standard input. As this is a development feature, there are a few limitations, such as the data sent to the external command is not guaranteed to be processed before the external application is shut down.
The general configuration of the external log processing is done in ncs.conf. Global and per-device settings controlling the external log processing for NED trace logs are stored in the CDB.
To enable external log processing, set /ncs-config/logs/external to true and /ncs-config/logs/command to the full path of the command that will receive the log data. The same executable will be used for all log types.
External configuration example:
To support the debugging of the external log command behavior, a separate log file is used. This debugging log is configured under /ncs-config/logs/ext-log. The example below shows the configuration for ./logs/external.log with the highest log level set:
By default, NED trace output is written to the file preserving backward compatibility. To write NED trace logs to file for all but the device test, which will use external log processing, the following configuration can be entered in the CLI:
When setting both external and file bits without setting /ncs-config/logs/external to true, a warning message will be logged to ext-log. When only setting the external bit, no logging will be done.
After enabling external log processing, NSO will start one instance of the external command for each configured log destination. Processing of the log data is done by reading from standard input and processing it as required.
The command line arguments provide information about the log that is being processed and in what format the data is sent.
The example below shows how the configured command ./log_processor would be executed for NETCONF trace data configured to log in raw mode:
Command line argument position and meaning:
version: Protocol version, always set to 1. Added for forward compatibility.
action: The action being performed. Is always set to log. Added for forward compatibility.
name: Name of the log being processed.
log-type: Type of log data being processed. For all but NETCONF and NED trace logs, this is set to system. Depending on the type of NED one of ned-trace-java, ned-trace-netconf and ned-trace-snmp is used. NETCONF trace is set to netconf-trace.
log-mode: Format of log data being sent. For all but NETCONF and NED trace logs, this will be raw. NETCONF and NED trace logs can be pretty-printed and then the format will be pretty.